Click
on any of the pictures below to see a larger version.
Crownline Classic equipped with audio, halogens, LEDs and security.
AUDIO
Four 8-inch diameter Bullet pods over the tower and staggered. Powdercoated pods in red (pulling the hull color) with clearcoat. ¾ - inch thick billet aluminum grills received polished edges with a brushed face and clear powdercoat.
Kenwood CD player indash with triple preamp outputs (front/in-boat, rear/tower and sub only).
Transom hardwired remote control.
Sirius marine antenna on bow deck cap.
iPod jack on dash with DC supply recepticle just beneath.
JL Audio six-channel amplifier concealed within helm console.
Set of Alpine marine coaxils in the bow.
Pair of Alpine coaxils in combing bolsters at the rear of cockpit. We also install carpet-clad birch enclosures to seal off the combing pockets so that the speakers are acoustically isolated front to back. This greatly impacts both the midbass and the power handling.
A third pair of Alpine marine coaxils added to the forward cockpit. This is the most important speaker location for an articulate and accurate full range sound.
Concealed up and under the port side helm console, an 8 – inch bass reflex subwoofer loads off the exterior hull.
HALOGENS
A seven lamp bar is powdercoated in red with a clearcoat. The seven halogen lamps are chrome. The bar and lamp color scheme matches the red speaker pods with polished grills. Whether brushed, polished or chromed, the silver and red contrast always looks good. Underdash switch to independently control the front and rear halogen lighting.
LED LIGHTING
Courtesy lights added to the bow.
Four courtesy lights in the cockpit are mounted to custom heat-formed aiming brackets to illuminate the drink holders and combing pockets.
Red LEDs illuminate frosted acrylic diffuser rings around the perimeter of four tower pods.
The billet grills also direct the red light toward the rear via eight slots per grill.
Underdash marine-grade switches with watertight boots control the tower light rings and courtesy lights.
SECURITY
Alarm status LED indash.
Exterior status LED in polymer bezel at transom and below the canvas cover.
Status LED in polymer bezel at the bow, and below the canvas cover.
Controlled by radio frequency keyfobs.
A float attached to each keyfob.
The tower pod light rings flash to confirm commands. Multiple external lights create a strobe effect in the event the alarm is triggered.
A siren wails while the factory horn honks in response to an attempted boarding.
A radar field proximity sensor is mounted beneath the sole to thwart any attempt to enter the boat’s space. Also, a closed loop circuit detects an attempt to come through the canvas top.
